Issue 53 April 2026

If you want to buy or sell miniature houses, dolls, furniture, books and all model railway units, new or used. Buying or selling used dolls, dollhouse miniatures, model trains, ships and planes and hobby items? Get started. M I N I S + MARKETPLACE Downsizing or Estate Disposal at market prices! WANTED! Dollhouses, Miniature furniture, Dolls, Tools We can find them new appreciative owners. We have had some success over the last two months in finding good homes for cherished doll houses. Contact Jill Email: jill@miniaturetimetraveller.com Super Bright LED for Hobbies and CraŌs. Code ASC on leŌ is controlled by a simple touch sensiƟve on/off switch. 10mm in diameter and 6 mm deep. Powered by CR927 baƩeries. BaƩeries included for orders of 3 or more. Magazine promoƟon: buy 5 or more for $6 each. The lights on the right Code BSM are controlled by a touch of a magnet, $3. Free magnet wand for orders over $30. $6.50 each plus p&p warm white/yellow, red, white. Other colours available by special order. Please state colour preferred and Code BSM when ordering. $6.50 each plus p&p of $5. warm white/yellow, red, white. Other colours available by special order. Please state preferred colour and Code ASC. Postage and packaging will not change regardless of quantity ordered. Email: jill@miniaturetimetraveller.com To create a realistic fire the key elements you will need are: 3 x 3 volt flickering orange LEDs and a connector. These are all in the package. You will need to purchase a nine volt battery and a switch and two colours of connecting wire separately. This pack is $ 5.00 plus p&p of $5. Postage will not change regardless of quantity ordered. Instructions on use to make a fire. You will need bare wire for these connections. See tip below. Wiring instructions: Solder a exposed red wire to each long leg of LED. Solder another coloured wire on each of the short legs. Twist the loose ends of the red wires together and insert in one side of the connector by holding down the lever. Release the lever and they will stay in place. Do the same with the negative wires. On the other side of the connector make sure you have the positive wire from the battery going to the same side as the red wires and the negative wire to the other side. Tip to expose both ends of the wires! Use a lighter, hold under the end of the wire until it catches fire then quickly snuƯ out with fingers. Pull the melted plastic down away from the unmelted wire cover and this will expose the copper wire inside. Do both ends. Miniature Time Traveller 35 3 x flickering 3 volt LEDs Email: jill@miniaturetimetraveller.com Connector